Project Essay Example | Topics and Well Written Essays - 1000 words

Project - Essay ExampleIt is also important to note that some motors produce immense output power, but rear endnot be efficient enough. It is under such(prenominal) conditions that people make practice session of H Bridge in the efficient control of the Motors direction. Project Fundamentals An H-bridge circuit refers to a power circuit that is electric, and used in the control of electric motors like DC motors used in automotive applications. The H-bridge functions in controlling the direction and speeding of the motor by allowing a limited amount of current to flow in the motor through the right direction (Barrett, 2012). It is made up of quaternity MOSFETs, which are under the control of control signals of the (PWM) Pulse Width Modulation. The original design of the DC motor control incorporates Multisim LabVIEW co-simulation that permits the performance of the entire system to be authenticated on the desktop. The motor has such parameters as inductance, the load weight, and a rmature resistance for accurate verification of the results of the performance. The use of a multisim-labVIEW co-simulation ensures that one shall not have to digital and analog systems separately. During the implementation stage of the model, the circuitry of the analog can be transferred for photocopying to the Ultiboard. Such a transition in the midst of the Ultiboard and Multisim makes sure that there is a precise shoot of simulated designs. The graphical code of control is moved to a Single Board Rio 9695 target. This is usually an acquisition device and an embedded control that puts together a FPGA that is user-reconfigurable, a real time processor, and input or output of printed circuit board. The four MOSFETs needed in designing a H-bridge can be present with the diagram below. Two of the MOSEFETs should be of P channel (IRF9540N), while the other two should be of N channel (IRF540N). They should be designed in such a way that the motors rotation is controlled through an on-off-on switch. The motors closed-loop control starts through inputs that are user-defined such as the necessary look size and speed. This message is resent to the Multisim design through the co-simulation terminals. Negotiations between labVIEW and Muiltisim occur as a guarantee in conversation and accuracy for both sides. In case of abrupt drops or peaks in Multisim, negotiation in time-step allows Multisim to alter the available time-step to view the drops and peaks. A point by point model between digital systems and analog circuits results to an advanced system both in accuracy and behavior. Once the verification of the system design has been made with Multisim and labVIEW co-simulation, the complete circuit can be moved to Ultiboard for routing and layout. List of Components The list of components used in the circuit includes MOSFET P Channel (IRF9540N) 2 MOSFET N Channel (IRF540N) 2 Motor DC 6 volts Battery 9 volts Switch 1 Connecting Wires and Strip Board Controlling the Motor The control of the motor is done through the two slipway switch connected to Q1 and Q3 of the circuit. If a signal is sent to Q1the motor is stimulated to move in a forward direction, while on the other hand, if a signal is sent to q3 the motor is stimulated run in a reverse direction. It is never possible to sent signals to both Q1 and Q3at the same time because of the use of on off on switch. This can be summarized using the following table Q1 Q3 Stop 0